Multi-Pure MP1200EL Owner's Manual download pdf (Page 19)

Congratulations, your Drinking Water System has been connected to your plumbing and you are now ready to

start-up the unit, as follows:

1. Using a paper towel or cloth, dry off all plumbing connections.

2. Also, dry off the drinking water unit.

3. Ensure that all connections are tight (CAUTION: DO NOT OVERTIGHTEN).

4. You are now ready to turn your water supply back on; turn on the plumbing Angle Stop

Valve under your sink or the water shut-off valve where water enters your residence.

5. Turn on the water going to your Drinking Water System by turning the handle on the Shut-off

Valve that you installed (see Section III).

6. Open the drinking water faucet by lifting the operating lever (handle) and lock in the up

position.

7. Allow water to run through the unit for about 5 minutes so that all air can escape.

8. Adjust the handle on the Shut-off Valve so that the water flow to the drinking water faucet does not exceed the flow rate

(0.75 gpm; to measure flow rate - it takes approximately 20 seconds to fill a quart at 0.75 gallons per minute)

9. Close the drinking water faucet and check for leaks.

a. Check the V-Band to confirm that it is secured evenly around the housing top and bottom.

b. Hand-tighten the black knob on the V-Band until it is as tight as possible.

10. Allow water to run through the unit to waste for approximately 20 minutes to flush the filter and charge the carbon.

11. Shut off the water and check for leaks.

Your Drinking Water System is now ready for use. You can enjoy having great tasting, high quality water for drinking, cook-

ing, beverages, food preparation, etc. whenever you want it.

Congratulations, you have completed the installation.

For optimum performance and to maintain the warranty on your Multi-Pure Drinking Water System, it is recommended that

your filter be replaced on a regular basis Filter life will vary depending on amount of water used and the type and level of

contaminants in your local water.

If you have any questions regarding the installation of your

Multi-Pure Drinking Water System, call:

Multi-Pure Corporation

Customer Relations Department

7251 Cathedral Rock Drive

Las Vegas, NV 89128

(702) 360-8880 phone

(800) 622-9206 toll-free

(702) 360-3110 fax

www.multipure.com

VIII START-UP AND USE OF YOUR MULTI-PURE DRINKING WATER SYSTEM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

No comments

Multi-Pure MP1200EL Owner's Manual Page 19