Multi-Pure MP1200EL Owner's Manual download pdf (Page 5)

The Models MP750SB, MP750SI, and MP1200EL Drinking Water Systems are designed for use below the sink and can

easily be installed on the incoming cold water line. The MP750SB and MP1200EL units are connected to a specially

designed stainless steel faucet (spigot) which installs directly on your sink, requiring little space. Your Below Sink Unit is

shipped with only one installation kit consisting of the accessories and fittings deemed appropriate for your area. Alternate

accessories may be purchased at a minimal cost.

Determine the Type of Installation

The type of plumbing in your home will determine whether you install your

Drinking Water System using the:

A. If you have the Pipe Adapter fixtures, review the below tool list require-

ments and proceed to Section II for instructions on installing the faucet and

then to Section III.A for connecting the unit to your plumbing.

B. Those residences with a cold water supply line without ½" slip joint may

use the Saddle Clamp to install their unit. If your unit includes the Saddle

Clamp fixtures, review the tool list requirements below and proceed to Section

II for instructions on installing the faucet and then to Section III.B for connect-

ing the unit to your plumbing.

C. If your residence has a feed water supply line with a 3/8" slip joint connec-

tion, you may use the optional Extender Tee Adapter to connect your drinking

water system to the plumbing. Proceed to Section II for installing the faucet

and then to Section III.C for connecting the unit to your plumbing.

The Multi-Pure Model MP750SI includes the housing, filter, and adapters; no

installation fixtures or accessories are provided. MP750SI is appropriate for

an in-line installation and can be used with your existing faucet. It is recom-

mended that the inline model be installed by a professional plumber in accor-

dance with established plumbing procedures.

Model MP750SB

Required Tool List

The following tools are required to install your below sink Multi-Pure Drinking Water System:

Installation of Faucet/Spigot (Ceramic/Porcelain Sink): Pipe Adapter Installation:

- 3/8" Reversible Electric Drill - 8" adjustable wrench

- 7/16" (or 1/2”) high speed steel drill bit - 5/8" open-end wrench

- ½" carbide tipped masonry drill bit - ½" open-end wrench

- Hammer - Screwdriver, Phillips (small)

- Center punch - Pliers or Vise Grips

- Wire Cutter or Knife

Installation of Faucet/Spigot (Stainless Steel Sink):

- all of the above (except masonry drill bit), plus….. Saddle Clamp Installation:

- 1/8" high speed drill bit - all of the above, plus…..

- ¼" high speed steel drill bit

Installation of MP1200EL Capacity Monitor: - Screwdriver, slotted (standard size)

- (see tool list in Section II.C)

Optional Extender Tee Adapter Installation:

- (see tool list in Section III.C)

I.C Below the Sink Installations

1 2 3 4 5 6 7 8 9 10 ... 29 30

Comments to this Manuals

No comments

Multi-Pure MP1200EL Owner's Manual Page 5

Comments to this Manuals