Multi-Pure MP1200EL Owner's Manual download pdf (Page 13)

Multi-Pure's below sink Models are designed for use under your sink. Your Below Sink Unit is shipped with only one instal-

lation kit consisting of the accessories and fittings deemed appropriate for your area. Alternate accessories may be pur-

chased at a minimal cost.

Now that you have completed the faucet installation and connected to the plumbing, it is time to prepare the housing for

completion of the installation.

The filter cartridge is shipped outside of the unit housing (in most cases) to protect your filter and drinking water system

from damage during shipping. Be sure to insert the filter cartridge into the drinking water system housing before finalizing

the installation. First, remove the plastic wrapper and instruction wrap from around the filter.

1. With the housing in an upright position, open the unit by unscrewing the black knob on

the Locking V-Band. Spread it apart and remove the Locking V-Band.

2. Separate the unit, leaving the black o-ring in place on the housing bottom.

3. Screw the new filter (cartridge) in the housing top, turning the cartridge in the direction

shown. Be sure that the filter has been screwed in STRAIGHT. DO NOT OVER

TIGHTEN.

4. Reconnect the housing top with bottom and replace Locking V-Band; replace black knob

and turn until tight. Be sure that the Locking V-Band is fastened tightly by:

a. Checking the V-Band to confirm that it is secured evenly around the housing top

and bottom.

b. Hand-tightening the black knob on the V-Band until it is as tight as possible.

turn to

connect

o-ring

v-band

IV PREPARING THE HOUSING

IV.A. Filter Cartridge Installation

Multi-Pure units are shipped with the connecting adapters appropriate for your Multi-Pure

Drinking Water System. The following shows the adapters that are shipped with the various

units. You will receive one INLET adapter and one OUTLET adapter. Now is the time to

attach the adapters to the housing top.

Blue Tubing connects the drinking water faucet to the OUTLET port on the housing.

Clear Tubing connects the plumbing to the INLET port on the housing.

The following adapters are used, depending on model and type of plumbing installation:

OUTLET

INLET

Large Straight

Adapter (#4)

MC730

Stem Adapter

(#15)

MC1414

Unit Shut-off

Valve (#11)

MC1875

Small Straight

Adapter (#4)

MC720

INLET

Adapter /

Valve

OUTLET

Adapters

IV.B Attaching the Adapters to the Housing

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Comments to this Manuals

No comments

Multi-Pure MP1200EL Owner's Manual Page 13

Comments to this Manuals