Multi-Pure MP1200EL Owner's Manual download pdf (Page 12)

If your residence has a cold water supply line with a 3/8" slip joint connection, you may

use the Extender Tee Adapter (optional) to connect your Drinking Water System to the

plumbing. Drinking Water Systems shipped with an Extender Tee Adapter include:

- Shut-off Valve with adapter (#11) - MC1875

- 3/8" Extender Tee Adapter Assembly (#13) - MC120 or (#14) MC165 (

PR tee)

which includes: 3/8" Compression Nut, Delrin Sleeve, Brass Insert

(for corresponding numbers, see diagram on page 4)

1. Install on the cold water line only.

2. Shut off your water at the cold water supply line - angle stop valve under your sink. You

should have on hand a container to catch any residual water in the pipes.

3. Disconnect the cold water riser/supply line at the angle stop valve by turning counter

clockwise the slip joint nut, using an 8" adjustable wrench.

4. Using the 8" adjustable wrench, connect the 3/8" Extender Tee Adapter to your angle

stop valve. Turn clockwise until tight; however, DO NOT OVERTIGHTEN.

5. Reconnect the cold water riser/supply line with the slip joint nut to the Extender Tee

Adapter. Turn clockwise until tight.

6. Connect the clear plastic tubing to the Extender Tee, as follows:

a. Insert the clear plastic tubing shipped with the unit through the small hole in the

3/8" compression nut (first unscrew the nut from the tee and remove the brass

sleeve - if found).

b. Insert the brass insert into the end of the plastic tubing.

c. Slide the plastic delrin sleeve, included with the assembly hardware, large end

first over the plastic tubing and insert into the compression nut (the brass

sleeve, if found, in the compression nut may be discarded).

d. Connect the 3/8" compression nut, with tubing attached, to the Extender Tee

Adapter by inserting tubing in the hole on the side of the extender tee adapter

as far as it will go. Tighten the compression nut by hand and then give one to

two extra turns with a wrench. Tighten securely, making sure the tubing does

not pull out, but DO NOT OVERTIGHTEN.

7. To connect the clear plastic tubing to your drinking water unit proceed to Section V.

NOTE: The shut-off valve will be connected to the inlet port on the unit top. See Section V

for instructions.

Water supply line

before installation.

sink

riser

cold

slip joint nut

Water supply line with

extender tee installed

III.C Extender Tee Adapter Installation

angle stop valve

angle stop

valve

extender tee

cold

riser

slip joint

nut

clear

tubing

to unit

clear plastic

tubing to unit

3/8”compression nut

brass insert

plumbing angle

stop valve

Extender Tee

Adapter

Connect to slip joint nut and cold

water supply line.

plastic delrin

sleeve

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Comments to this Manuals

No comments

Multi-Pure MP1200EL Owner's Manual Page 12

Comments to this Manuals