Multi-Pure MP1200EL Owner's Manual download pdf (Page 8)

II.C Installing the Faucet with a Capacity Monitor

Your Multi-Pure Drinking Water System is equipped with a DigiFlow 5000V Capacity Monitor that flashes red when the

filter should be changed. Models with capacity monitors are equipped with a stainless sttel faucet with the tubing attached.

In addition you will receive the DigiFlow 5000V Capacity Monitor, two adapters, and additional blue tubing

(see diagram and parts list below). Not included but required for installation: two AAA batteries.

1 spout

2 faucet handle

3 faucet base

4 cover plate

5 capacity indicator

plate (black)

6 red & black wire

7 rubber washer

8 track washer

9 adapters

(MC744)

10 tubing from

faucet to monitor

11 tubing from

housing to monitor

12 Electronics Box

DigiFlow

5000V

Electronics Box

Faucets with Capacity

Monitor include:

Mounting the Faucet with a Capacity Monitor:

1. Follow the preceding instructions for drilling the hole; however, use the 1/2”

drill bit all the way through the sink instead of the 7/16” drill bit to allow room to

feed the faucet stud and the monitor cable down through the hole in the sink.

2. Note that the tubing is attached to the faucet. Before mounting the faucet

on your sink:

a. Carefully remove the plastic packing tube from the hole in the base

(CAUTION: do not remove the faucet handle (operating lever).

b. With the operating lever in the "up" position, insert the spout: First wet the

o-ring area of the spout, using hot water, and insert spout in the hole in the

faucet base from which packing tube was removed. Once the spout is

connected, the faucet handle can be released.

3. From the sink top, place over the faucet hole:

a. The black rubber washer.

b. Then the Capacity Indicator Plate; first feed the red & black cable through

the hole. Position the Capacity Indicator Plate so that the indicator light will

be easy to see.

c. Place the Faucet Cover Plate (#4) over the Capacity Indicator Plate

(#5) so that the Cover Plate is visible from above the sink.

d. Place the faucet base (#3) on the Cover Plate, feeding the faucet stud down

through the hole in the sink; the faucet stud will now be accessible from

below the sink.

4. From below the sink, do the following:

a. Slide the black Channel "track" washer over the threaded faucet stud with

the flat side down. Guide the red & black wires through the "track" to

assure that the cable will be protected in the track and not be pinched

between the sink /counter and the stud nut.

b. Slide the lock washer on the faucet stud.

c. Screw on the Stud Nut, hand-tightening it just enough to keep the faucet

secure on the sink top.

Countertop

tubing from

faucet

tubing from

housing

Installation Overview

DigiFlow

5000V

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Comments to this Manuals

No comments

Multi-Pure MP1200EL Owner's Manual Page 8

Comments to this Manuals